Fastening Systems Tools Gym Gymnasium

Pneutek

Gymnasium and Sub Flooring

Plywood to 14 ga. structural framing

Plywood to 14 ga. structural framing

Plywood to steel ledger

Plywood to steel ledger

Man with Goggles and Flooring Tool

Using a flooring tool

The Air/Safe^® Fastening System by Pneutek^® meets all your sub-floor and gymnasium flooring installation requirements...

Fast
Five to ten times faster than using powder actuated tools or anchors. The Pneutek^® low velocity PT1100SUI has repeater action so you can drive up to 20 pins in quick succession without reloading. Produces up to 1200 in-place fastenings per hour.

Safe
Every Pneutek^® fastening tool has completely tamper-proof cocking. Virtually no chance of misfire. Meets or exceeds all O. S. H. A. safety requirements.

Easy to Use
No loud noise, no sharp recoil, no residue from burning explosives, and no time out for cleaning or oiling. The Pneutek^® system requires very little applied force. Fastening is rapid with minimum operator fatigue.

Positive Attachments
The Pneutek^® system provides high fastener holding power, both in tensile and shear strength. Meets or exceeds 900 lb. pull out and 1300 lb. shear requirements.

Pneutek^® Gym Flooring Fasteners

Nailing Pins

Pneutek^® fasteners are supplied in strips of 10 pins. They can be quickly loaded, one or two strips at a time, into the tool's self-feeding magazine

FASTENER RECOMMENDATION GUIDE

Fastener	Shank Length	Shank Type¹	Materials Attached²
44125L	1 1/4"	Smooth	Clip Type & Grip-Tite Flooring
SDL45138L	1 3/8"	Step Down Smooth	Clip Type & Grip-Tite Flooring
44138L	1 3/8"	Smooth	Clip Type & Grip-Tite Flooring
SDL45150L	1 1/2"	Step Down Smooth	Strip Type Flooring & Sub-Floor
44150L	1 1/2"	Smooth	Strip Type Flooring & Sub-Floor
44175L	1 3/4"	Smooth	Strip Type Flooring
SDL45225L	2 1/4"	Step Down Smooth	Strapping

For concrete compressive strength of 3000-4000 psi use smooth
shank fasteners; over 4000 psi use stepped down shank fasteners.

PRELIMINARY application..
specific each for fasteners Pneutek of value holding the verify to conducted be must tests out pull>Recommended operating pressure 145 psi.

Gym Flooring and Sub-Flooring Tools

Auxiliary Tank Assembly and Air Hose

Gym Flooring
Model No: PT 1100 SUI with 1 1/2" magazine.

Sub-Floor
Model No: PT 1100 SUI with 2" magazine.

Model No: ATA-20
20 Gal. ASME tank assembly equipped
with pressure regulator, safety valve and

quick disconnect.

Model No: AHA-50
50', 300 psi air hose assembly with
3/8" quick disconnect.

Pneutek Air Compressor

Model No PC-2S5E-20 5 HP
230 volt,60Hz, single phase 2-stage heavy duty pump
20 gallon ASME tank delivers 17 CFM @ 50 psi.

PNEUTEK

17 Friars Drive Hudson, NH 03051
Toll Free: 800-431-8665 • Phone: 603-883-1660 • Fax: 603-882-9165
E-mail: technical@pneutek.com